The installation details of glass door floor spring:

来自:永之兴门控 发布时间:2020-11-18
摘要:The installation details of glass door floor spring:

The installation details of glas

Attention should be paid to the installation details of glass door floor spring:

1、 The frame of glass door is made of steel beam,The upper and lower door shafts are on a vertical line, and the upper shafts are welded on the beam, As the upper door shaft is the support of the whole glass door, it should be solid,It is forbidden to select the upper crossbeam and select the fine wood board and wood keel structure, Since the connection point between the upper door shaft and the wooden structure can only be fixed with self tapping screws, Due to the number of times to open the door, the door shaft is easy to fall off, causing danger.

2、 When the spring is pre buried, a rectangular square pit shall be chiseled on the original place,

It should be 10 mm larger than the floor spring base, It is used to plug high-grade cement mortar,

It has a strong effect. It is suggested that the ground spring cement should be set for 48 hours according to the glass door. The ground edge of the glass door should be 8-12 mm away from the ground to prevent the glass door from colliding with the ground when it is sagging.

3、 The upper and lower shafts of the door should be located in the center of the door frame, After installation, the glass door can also seat in the center of the door frame. The edge of the glass door should be 3-6 mm away from the crossbeam to prevent the connection between the upper door shaft and the door clip from separating when the door is sagging. There is another detail to be noted. Grease should be injected into the position of the door shaft and the door clip, which can reduce the wear of the connecting parts and extend the service life.

地弹簧生产厂家

地弹簧生产厂家

s door floor spring:


首页 联系电话 邮箱